Data List / Active Test

HINT:

By reading the DATA LIST displayed on an intelligent tester, you can check values, including those of the switches, sensors, and actuators, without removing any parts. Reading the DATA LIST as the first step in troubleshooting is one method of shortening diagnostic time.

1. Put the engine in inspection mode (See CHECK MODE PROCEDURE ).
2. Warm up the engine.
3. Turn the ignition switch off.
4. Connect the intelligent tester (with CAN VIM) to the DLC3.
   Fig 1: Connecting Cable Of Intelligent Tester (With CAN VIM) To DLC3

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Turn the ignition switch to the ON position.
6. Turn the tester on.
7. Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DATA LIST.
8. Check the values by referring to the table below.
   TESTER DISPLAY AND NORMAL CONDITION CHART
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   FUEL FILLER OPN	Fuel lid opener motor actuating signal: ON or OFF	ON: Motor is actuated OFF: Motor is not actuated	-
   FUEL LID	Fuel lid courtesy switch: OPEN or CLOSE	OPEN: Fuel lid is opened CLOSE: Fuel lid is closed	-
   FUEL LID SW	Fuel lid opener switch: ON or OFF	ON: Fuel lid opener switch is pressed OFF: Fuel lid opener switch is not pressed	-

HINT:

Performing an ACTIVE TEST enables components including the relays, VSV (Vacuum Switching Valve) and actuators, to be operated without removing any parts. The ACTIVE TEST can be performed with an intelligent tester. Performing an ACTIVE TEST as the first step in troubleshooting is one method of shortening diagnostic time.

DATA LIST can be displayed during ACTIVE TEST.

1. Put the engine in inspection mode (See CHECK MODE PROCEDURE ).
2. Connect the intelligent tester (with CAN VIM) to the DLC3.
   Fig 2: Connecting Cable Of Intelligent Tester (With CAN VIM) To DLC3

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Turn the ignition switch to the ON position.
4. Turn the tester on.
5. Enter the following menus: DIAGNOSIS / ENHANCED OBD II / ACTIVE TEST.
6. Perform the ACTIVE TEST by referring to the table below.
   TESTER DISPLAY REFERENCE
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   FUEL FILLER OPN	Fuel lid opener control	ON / OFF	-