LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Highlander Hybrid Limited, AWD >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Engine Immobilizer (Hybrid) >> Engine Immobilizer System >> DTC Check / Clear

DTC Check / Clear

  1. CHECK THE DTC 
    1. Connect the intelligent tester to the Controller Area Network Vehicle Interface Module (CAN VIM). Then connect the CAN VIM to the DLC3.
      2. Fig 1: Connecting Intelligent Tester (With CAN VIM) To DLC3
      G05242986Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Turn the ignition switch on.
    3. Read the DTCs by following the prompts on the tester screen.

      HINT:

      Refer to the intelligent tester operator's information for further details.

  2. CLEAR THE DTC 
    1. Connect the intelligent tester (with CAN VIM) to the DLC3.
    2. Turn the ignition switch on.
    3. Erase the DTCs by following the prompts on the tester screen.

      HINT:

      Refer to the intelligent tester operator's information for further details.

scientia non olet · About LEMON Manuals