LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Highlander Hybrid Limited, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior (Hybrid) >> Roof Drip Side Finish Moulding >> Removal

Roof Drip Side Finish Moulding: Removal

  1. REMOVE ROOF DRIP SIDE FINISH MOULDING 
    1. Cover the circumference of the moulding with protective tape for protection.
    2. Using a remover for the roof moulding, release the engagements of the clips in both front and rear ends of the moulding, and then remove the roof drip side finish moulding.
      NOTE:
      • Do not remove the clips.
      • In case that the clips are damaged or removed accidentally, replace them with new ones.
      Fig 1: Removing Roof Drip Side Finish Moulding
      G05205583Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals