Rear Spoiler: Removal

REMOVE REAR SPOILER
1. Remove the 2 bolts and nut.
  
  Fig 1: Installing Rear Spoiler With Bolts And Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a heat light, heat the body and rear spoiler surface to 40 to 60°C (104 to 140°F).
  NOTE: Do not heat the body and rear spoiler excessively.
3. Tie both piano wire ends to wooden blocks or equivalents.
4. Scrape the adhesive tape off by pulling the piano wire.
  NOTE:
  - If reusing the rear spoiler, take care not to damage the rear spoiler.
  - Do not damage the body.
  Fig 2: Identifying Adhesive Tape
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Release the clip and remove the rear spoiler.