LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Highlander Hybrid Limited, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior (Hybrid) >> Rear Door Belt Moulding >> Removal

Rear Door Belt Moulding: Removal

  1. REMOVE REAR DOOR INSIDE HANDLE BEZEL  (See DISASSEMBLY )
  2. REMOVE DOOR PULL HANDLE  (See DISASSEMBLY )
  3. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY  (See DISASSEMBLY )
  4. REMOVE REAR DOOR BELT MOULDING ASSEMBLY LH 
    1. Remove the screw.
    2. Put protective tape under the rear door belt moulding assembly LH.
    3. Using a moulding remover or scraper, remove the rear door belt moulding assembly LH.
      Fig 1: Identifying Rear Door Belt Moulding Assembly
      G05205581Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals