Outside Moulding: Removal

REMOVE OUTSIDE MOULDING
1. Using a heat light, heat the body and moulding to 40 to 60°C(104 to 140°F).
  NOTE: Do not heat the body and moulding excessively.
2. Tie both piano wire ends to wooden blocks or equivalents.
3. Scrape the adhesive tape off by pulling the piano wire as shown in the illustration.
  NOTE:
  - If reusing the moulding, take care not to damage it.
  - Do not damage the body.
  Fig 1: Scraping Adhesive Tape Off Using Piano Wire
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002