LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Highlander Hybrid Limited, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior (Hybrid) >> Front Door Belt Moulding >> Removal

Front Door Belt Moulding: Removal

  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL  (See DISASSEMBLY )
  2. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY  (See DISASSEMBLY )
  3. REMOVE DOOR PULL HANDLE  (See DISASSEMBLY )
  4. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH  (See DISASSEMBLY )
  5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY  (See DISASSEMBLY )
  6. REMOVE FRONT DOOR BELT MOULDING ASSEMBLY 
    1. Remove the screw.
    2. Put protective tape under the front door belt moulding assembly.
    3. Using a moulding remover or scraper, remove the front door belt moulding assembly.
    Fig 1: Removing Front Door Belt Moulding Assembly
    G05205579Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals