LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Highlander Hybrid Limited, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter (Hybrid) >> Fuel Sender Gauge Assembly >> Inspection

Fuel Sender Gauge Assembly: Inspection

  1. INSPECT FUEL SENDER GAUGE ASSEMBLY 
    1. Remove the fuel sender gauge assembly.
      Fig 1: Identifying Fuel Sender Gauge Connector Terminals
      G05204546Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check that the float moves smoothly between F and E.
    3. Disconnect the fuel sender gauge connector.
    4. Measure the resistance between terminals 1 (FE) and 2 (FS) of the connector according to the value(s) in the table below.

      Standard Resistance 

      RESISTANCE REFERENCE CHART

      Float Level Resistance (Ω)
      F 13.5 to 16.5
      E 405.5 to 414.5

      HINT:

      If the value is not as specified, replace the fuel sender gauge assembly.

scientia non olet · About LEMON Manuals