LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Highlander Hybrid Limited, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter (Hybrid) >> Combination Meter >> Removal

Combination Meter: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working (See AIRBAG SYSTEM ).
  2. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER 
    1. Using a molding remover, disengage the 5 clips.
      2. Fig 1: Identifying Clips
      G05243350Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the connectors, and remove the instrument panel finish panel lower.
  3. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY 
    1. Using a molding remover, disengage the 5 clips, and remove the instrument cluster finish panel assembly.
      Fig 2: Identifying Instrument Cluster Finish Panel Assembly
      G05243351Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH 
    1. Remove the 4 screws.
    2. Disengage the claw, and remove the instrument cluster finish panel garnish.
      Fig 3: Identifying Instrument Cluster Finish Panel Garnish
      G05243352Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE COMBINATION METER ASSEMBLY 
    1. Remove the 3 screws, and pull the combination meter assembly.
      Fig 4: Identifying Combination Meter Assembly
      G05243353Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the connectors.
scientia non olet · About LEMON Manuals