Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the Highlander Base, 2.4 D, AWD, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All | 1.8 | B | ||
| Front or Rear,Both Sides | 1.0 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Base,Limited,Sport, One | Includes: Bleed Brakes. | 0.3 | B | |
| Each Additional | Includes: Bleed Brakes. | 0.2 | B | |
| Combination Procedure: CALIPER: Replace: | ||||
| Base,Limited,Sport, One | Includes: Bleed Brakes. Includes: Additional time for use of scan tool to perform this procedure. | 0.5 | B | |
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DISC ROTOR: Correct: | ||||
| Lateral Runout,Each | Correct Rotor lateral runout by indexing. | 0.2 | B | |
| Combination Procedure: HUB & ROTOR DISC: Clean & Inspect: | ||||
| Corrosion,Each | Clean any rust or corrosion from mating surface of Hub/Axle Flange and Brake Rotor. | 0.2 | B | |
| Combination Procedure: PARKING BRAKE SHOE & LINING: Replace: Includes: Clean, lube and/or replace Parking Brake Hardware (as necessary). DOES NOT include refinishing. | ||||
| Each Side | 0.4 | B | ||