Brake Master Cylinder: Removal

DRAIN BRAKE FLUID
NOTE: Wash brake fluid off immediately if it adheres to any painted surface.
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
REMOVE BRAKE MASTER CYLINDER SUB-ASSEMBLY
1. Disconnect the brake fluid level switch connector from the reservoir sub-assembly.
2. M/T:
  Slide the clip and disconnect the clutch reservoir tube No. 1 from the reservoir sub-assembly.
3. Using SST, disconnect the 2 brake tubes from the master cylinder sub-assembly.
  SST 09023-00101
  
  Fig 1: Locating Brake Tubes From Master Cylinder Sub-Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Using SST, disconnect the 2 or 3 brake tubes from the No. 1 way.
  SST 09023-00101
  
  Fig 2: Locating Brake Tubes From No. 1 Way
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the 2 nuts, pull out the master cylinder sub-assembly and No. 1 way, and check the valve bracket.
  
  Fig 3: Identifying Valve Bracket Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002