Differential Oil Seal: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL TRANSAXLE CASE OIL SEAL
1. Coat a new oil seal lip with MP grease.
2. Using SST and a hammer, install the oil seal.
  SST 09710-20011 (09710-06071), 09950-70010 (09951-07200)
  
  Drive in depth: 1.6 to 2.2 mm (0.063 to 0.087 in.)
  
  NOTE: Be careful not to damage the oil seal lip.
  
  Fig 1: Installing Front Transaxle Case Oil Seal
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL TRANSMISSION CASE OIL SEAL
1. Coat a new oil seal lip with MP grease.
2. Using SST and a hammer, install the oil seal.
  SST 09726-36010, 09950-70010 (09951-07200)
  
  Drive in depth: 9.6 to 10.2 mm (0.378 to 0.402 in.)
  
  NOTE: Be careful not to damage the oil seal lip.
INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
HINT:

(See INSTALLATION )

Fig 2: Installing Transmission Case Oil Seal
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL FRONT DRIVE SHAFT ASSEMBLY RH (See INSTALLATION )
INSTALL FRONT WHEELS
Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf)
ADD MANUAL TRANSAXLE OIL
1. Add the manual transaxle oil.
  Oil grade: API GL-4 or GL-5
  
  Viscosity: SAE 75 W-90
  
  Capacity: 1.9 liters (2.0 US qts, 1.7 lmp. qts)
  
  Torque: 39.2 N*m (400 kgf*cm, 29 ft.*lbf)
  
  Fig 3: Identifying Manual Transaxle Oil Level
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT AND ADJUST MANUAL TRANSAXLE OIL
INSPECT AND ADJUST FRONT WHEEL ALIGNMENT
HINT:

(See ADJUSTMENT )
CHECK ABS SPEED SENSOR SIGNAL
1. Anti-lock Brake System (See TEST MODE PROCEDURE )
2. Vehicle Stability Control System (See TEST MODE PROCEDURE )