LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Corolla CE, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical (1ZZ-FE) >> Engine Rear Oil Seal >> Removal

Engine Rear Oil Seal: Removal

  1. REMOVE MANUAL TRANSAXLE ASSEMBLY (for Manual Transaxle) 
    1. Remove the manual transaxle assembly (See REMOVAL ).
  2. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for Automatic Transaxle) 
    1. Remove the automatic transaxle assembly (See REMOVAL ).
  3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transaxle) 
    1. Remove the clutch cover assembly (See REMOVAL ).
  4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transaxle) 
    1. Remove the clutch disc assembly (See REMOVAL ).
  5. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transaxle) 
    1. Using SST, hold the crankshaft.

      SST 09960-10010 (09962-01000, 09963-01000) 

    2. Remove the 8 bolts and flywheel.
    Fig 1: Holding Crankshaft Using SST
    G05192920Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE DRIVE PLATE & RING GEAR SUB-ASSEMBLY (for Automatic Transaxle) 
    1. Using SST, hold the crankshaft.

      SST 09960-10010 (09962-01000, 09963-01000) 

    2. Remove the 8 bolts and drive plate & ring gear.
    Fig 2: Holding Crankshaft Using SST
    G05192920Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. REMOVE ENGINE REAR OIL SEAL 
    1. Using a knife, cut off the oil seal lip.
    2. Using a screwdriver with its tip wrapped with tape, pry out the oil seal.
      NOTE: After removing, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.
Fig 3: Removing Engine Rear Oil Seal
G05192922Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals