Front Brake Pad, Brake Caliper & Brake Rotor: Removal

HINT:

Overhaul the RH side by the same procedure as the LH side.

1. REMOVE FRONT WHEEL 
2. DRAIN BRAKE FLUID 
   NOTE: Wash the brake fluid off immediately if it comes into contact with any painted surface.
3. REMOVE FRONT DISC BRAKE CYLINDER SUB-ASSEMBLY 
   1. Remove the union bolt and gasket from the disc brake cylinder, then disconnect the flexible hose.

      HINT:

      Gasket has 2 types: 2-piece type and 1-piece type.

      Fig 1: Locating Flexible Hose

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Hold the cylinder slide pin and remove the 2 bolts.
      Fig 2: Locating Cylinder Slide Pin And Bolt

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002