Inspection Procedure

1. Disconnect the B6 connector from the front seat inner belt assembly (Driver side).
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester connection	Condition	Specified condition
   B6-5 - B6-6	Seat belt is fastened	10 kΩ or higher
   B6-5 - B6-6	Seat belt is not fastened	Below 1 Ω

NG: REPLACE FRONT SEAT INNER BELT ASSEMBLY (DRIVER SIDE) 

Fig 1: Inspecting Front Seat Inner Belt Assembly (For Driver Side)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: GO TO Next Step 

1. Disconnect the C9 and B6 connectors.
2. Measure the resistance according to the value(s) in the table below.

   Standard resistance 

   TESTER CONNECTION SPECIFIED CONDITION CHART
   
   

   Tester connection	Condition	Specified condition
   C9-12 - B6-5	Always	Below 1 Ω
   C9-12 - Body ground	Always	10 kΩ or higher
   B6-6 - Body ground	Always	Below 1 Ω

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

Fig 2: Checking Harness And Connector (Combination Meter - Front Seat Inner Belt Assembly)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK: REPLACE COMBINATION METER ASSEMBLY