Tire And Wheel System: Inspection

INSPECT TIRE

Check the tires for wear and proper inflation pressure.

Cold tire inflation pressure

TIRE SPECIFICATION

Tire Size	Front kPa (kgf/cm² , psi)	Rear kPa (kgf/cm² , psi)
215/60R16 94 V	200 (2.0, 29)	200 (2.0, 29)
215/55R17 93 V	220 (2.2, 32)	220 (2.2, 32)

Using a dial indicator, check the tire runout.
Tire runout:

1.4 mm (0.055 in.) or less

Fig 1: Checking Tire Runout

ROTATE TIRES
1. Rotate the tires as shown in illustration (B). If the vehicle is equipped with a grand spare tire, rotate the tires as shown in illustration (A).
Fig 2: Tire Rotation Pattern
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT WHEEL BALANCE
1. Check and adjust the off-the-car balance.
2. If necessary, check and adjust the on-the-car balance.
  Imbalance after adjustment:
  
  8.0 g (0.018 lb) or less
Fig 3: Displaying Wheel Balancer
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT FRONT AXLE HUB BEARING LOOSENESS (See INSTALLATION )
INSPECT REAR AXLE HUB BEARING LOOSENESS (See ON-VEHICLE INSPECTION )
INSPECT FRONT AXLE HUB RUNOUT (See ON-VEHICLE INSPECTION )
INSPECT REAR AXLE HUB RUNOUT (See ON-VEHICLE INSPECTION )