Front Passenger Airbag Assembly: Installation

INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
INSTALL INSTRUMENT PANEL WIRE ASSEMBLY
1. Connect the 2 connectors to the front passenger airbag assembly.
  NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
2. Install the clip.
INSTALL HEATER TO REGISTER DUCT NO.3
INSTALL SIDE DEFROSTER NOZZLE DUCT NO.2
INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
HINT:

Refer to procedures from "INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY" (See INSTALLATION ).
CONNECT FRONT PASSENGER AIRBAG ASSEMBLY CONNECTOR
1. Connect the connector.
  NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
  
  Fig 1: Locating Front Passenger Airbag Assembly Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL INSTRUMENT PANEL FINISH LOWER PANEL RH
INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO.2
INSTALL FRONT DOOR WEATHERSTRIP RH
INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
INSTALL FRONT DOOR SCUFF PLATE RH
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT STEERING PAD
PERFORM INITIALIZATION
1. Perform initialization (See INITIALIZATION ).
  HINT:
  
  Some systems need initialization when disconnecting the cable from the negative battery terminal.
INSPECT SRS WARNING LIGHT
1. Inspect the SRS warning light (See DIAGNOSIS SYSTEM ).