Driver Side Knee Airbag Assembly: Removal
- PRECAUTION CAUTION: Be sure to read the "PRECAUTION" thoroughly before servicing (See PRECAUTION in AIRBAG SYSTEM).
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
- REMOVE FRONT DOOR SCUFF PLATE LH (See REMOVAL )
- REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH (See REMOVAL )
- REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
- REMOVE INSTRUMENT PANEL FINISH LOWER PANEL LH (See REMOVAL )
- REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY
- Remove the 4 bolts and the driver side knee airbag assembly.
- Disconnect the connector from the driver side knee airbag assembly.NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.
- INSPECT DRIVER SIDE KNEE AIRBAG ASSEMBLY