Temperature Control Switch: Removal

HINT:

Installation is in the reverse order of removal.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   1. Wait for 90 seconds after disconnecting the cable to prevent the airbag working.
2. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH NO. 2  (See REMOVAL )
3. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY  (See REMOVAL )
4. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY CENTER 
   1. Release the 8 claws and 5 clips and instrument cluster finish panel sub-assembly center.
   2. Disconnect the connector and remove the instrument cluster finish panel sub-assembly center.
   Fig 1: Identifying Claws And Clips

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002