Rear Axle Hub And Bearing: Removal

HINT:

• Use the same procedures for the RH side and LH side.
• The procedures listed below are for the LH side.

1. REMOVE REAR WHEEL 
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH 
   1. Remove the bolt and separate the flexible hose from the shock absorber.
      Fig 1: Locating Flexible Hose Bolt

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Remove the 2 bolts and separate the rear disc brake caliper assembly LH.
      NOTE: Use a wire or an equivalent to keep the brake caliper from hanging down by the flexible hose.
      Fig 2: Locating Rear Disc Brake Caliper Assembly LH Bolts

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. REMOVE REAR DISC 
4. DISCONNECT SKID CONTROL SENSOR 
   1. Disconnect the skid control sensor connector.
5. REMOVE REAR AXLE HUB & BEARING ASSEMBLY LH 
   1. Remove the 4 bolts and hub & bearing assembly LH.
   Fig 3: Locating Hub & Bearing Assembly LH Bolts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002