Parking Brake Pedal: Reassembly

INSTALL PARKING BRAKE CABLE ASSEMBLY NO.1
1. Pass the parking brake cable assembly No.1 through the parking brake control pedal and hold the cable with the clip.
2. Pass the parking brake cable through the pedal guide. Temporarily tighten the wire adjusting nut No.1 and lock nut.
  HINT:
  
  Fully tighten the wire adjusting nut No.1 and lock nut when adjusting the parking brake pedal free play.
3. Fully bend the parking brake pedal claw.
  
  Fig 1: Locating Parking Brake Cable Assembly Claw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL PARKING BRAKE SWITCH ASSEMBLY
1. Install the parking brake switch assembly with the screw.
  Torque: 0.9 N*m (9 kgf*cm, 7.8 in.*lbf)
  
  Fig 2: Identifying Parking Brake Switch Assembly With Screw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL PARKING PEDAL PAD
1. Engage the claw and install the parking pedal pad on the parking brake control pedal assembly.
  
  Fig 3: Identifying Parking Pedal Pad Claw
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002