LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Avalon XLS >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brake >> Parking Brake Assembly >> Disassembly

Parking Brake Assembly: Disassembly

  1. REMOVE REAR WHEEL 
  2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH 
    1. Remove the 2 bolts and separate the rear disc brake caliper assembly LH.

      HINT:

      Do not disconnect the flexible hose from the disc brake caliper assembly LH.

      Fig 1: Locating Rear Disc Brake Caliper Assembly With Bolts
      G05001763Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE REAR DISC 
    1. Release the parking brake.
    2. Put matchmarks on the rear disc and the axle hub.
      Fig 2: Identifying Matchmarks On Rear Disc And Axle Hub
      G05001764Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Remove the rear disc.

      HINT:

      If the disc cannot be removed easily, turn the shoe adjuster until the wheel turns freely.

      Fig 3: Removing Rear Disc
      G05001765Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE PARKING BRAKE SHOE RETURN TENSION NO. 1 SPRING 
    1. Using needle-nose pliers, remove the 2 parking brake shoe return tension No. 1 springs.
    Fig 4: Locating Return Tension Springs
    G05001766Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE PARKING BRAKE SHOE STRUT LH 
    1. Remove the parking brake shoe strut LH and parking brake shoe strut compression spring.
  6. REMOVE PARKING BRAKE SHOE 
    1. Release the spring cup claw and remove the No. 1 parking brake shoe assembly and No. 2 parking brake shoe assembly.
      2. Fig 5: Locating Spring Cup Claw
      G05001767Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the parking brake cable assembly No. 3 from the shoe lever.
    3. Remove the parking brake shoe return tension No. 2 spring and adjusting screw set from the No. 1 parking brake shoe assembly and No. 2 parking brake shoe assembly.
    4. Remove the 2 hold down compression springs, parking brake shoe hold down spring No. 1 cup and parking brake shoe hold down spring No. 2 cup.
    5. Remove the parking brake shoe hold down spring No. 1 pin and parking brake shoe hold down spring No. 2 pin.
    6. Using a screwdriver, remove the C-washer.
      Fig 6: Identifying C-Washer
      G05001768Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    7. Remove the shim and shoe lever from the No. 2 parking brake shoe assembly LH.
  7. REMOVE PARKING BRAKE SHOE GUIDE PLATE 
    1. Remove the parking brake shoe guide plate set bolt and the parking brake shoe guide plate.
      Fig 7: Identifying Parking Brake Shoe Guide Plate
      G04978553Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals