LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Avalon XLS >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Rear Brake Pad, Brake Caliper & Brake Rotor >> Reassembly

Rear Brake Pad, Brake Caliper & Brake Rotor: Reassembly

  1. INSTALL REAR DISC BRAKE BLEEDER PLUG 
  2. INSTALL REAR DISC BRAKE BLEEDER PLUG CAP 
  3. INSTALL PISTON SEAL 
    1. Apply lithium soap base glycol grease to a new piston seal.
    2. Install the piston seal to the disc brake cylinder assembly rear.
  4. INSTALL REAR DISC BRAKE PISTON
    1. Apply lithium soap base glycol grease to the piston and a new cylinder boot.
    2. Install the cylinder boot to the piston.
    3. Install the piston to the disc brake cylinder assembly rear.
      NOTE: Do not install the piston forcibly in the cylinder assembly rear.
    Fig 1: Applying Lithium Soap Base Glycol Grease To Piston And Cylinder Boot
    G05001724Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL CYLINDER BOOT 
    1. Install the cylinder boot to the disc brake cylinder assembly rear.
      NOTE: Install the cylinder boot securely into the grooves of the cylinder and piston.
      Fig 2: Identifying Cylinder Boot
      G05001725Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using a screwdriver, install a new set ring.
      NOTE:
      • Install the set ring securely into the grooves of the cylinder boot.
      • Do not damage the cylinder boot.

      HINT:

      Tape the screwdriver tip before use.

scientia non olet · About LEMON Manuals