LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2007 >> Avalon XLS >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Brake Master Cylinder >> Installation

Brake Master Cylinder: Installation

  1. INSTALL BRAKE MASTER WITH PLATE CYLINDER SUB-ASSEMBLY 
    1. Install the master cylinder sub-assembly and 2-way with the 2 nuts.

      Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf) 

      Fig 1: Installing Master Cylinder Sub-Assembly And Way With Nuts
      G05001675Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Using SST, connect the 6 brake tubes to the master cylinder sub-assembly.

      Torque: 15 N*m (155 kgf*cm, 11 ft.*lbf) 

      SST 09023-00101 

      Fig 2: Connecting Brake Tubes To Master Cylinder Sub-Assembly
      G05001674Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Connect the level warning switch connector.
  2. FILL RESERVOIR WITH BRAKE FLUID  (See BRAKE FLUID )
  3. BLEED MASTER CYLINDER  (See BRAKE FLUID )
  4. BLEED BRAKE LINE  (See BRAKE FLUID )
  5. INSTALL AIR CLEANER ASSEMBLY 
  6. CHECK FLUID LEVEL IN RESERVOIR  (See BLEEDING )
  7. INSPECT FOR FLUID LEAK 
scientia non olet · About LEMON Manuals