Rear Seat Assembly: Removal

HINT:

Only installation procedures requiring additional information are included.

1. REMOVE REAR SEAT CUSHION ASSEMBLY 
   1. Pull up the 2 portions of the rear seat cushion assembly as shown in the illustration and remove it.

      A: 

      100 mm (3.94 in.) or less 

      NOTE: In this case, hold the base of the clip up to prevent the cushion frame from being distorted.
   2. Disconnect each wire of the reclining adjuster arm sub-assembly RH and remove the rear seat cushion assembly.
2. REMOVE REAR SEAT HEADREST ASSEMBLY 
3. REMOVE REAR SEATBACK LOCK COVER CAP 
   1. Disengage the 6 claws and remove the 2 RR shelf cover caps.
   Fig 1: Pulling Up Portions Of Rear Seat Cushion Assembly

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   Fig 2: Identifying RR Shelf Cover Caps

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. REMOVE REAR SEATBACK ASSEMBLY LH 
   1. Remove the rear seat belt from the rear seat shoulder belt guide LH.
      Fig 3: Locating Rear Seat Belt

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Remove the bolt, 2 nuts and the rear seatback assembly LH.
   Fig 4: Identifying Rear Seatback Assembly LH

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. REMOVE REAR SEATBACK ASSEMBLY RH 
   1. Remove the rear seat belt from the rear seat shoulder belt guide RH.
      Fig 5: Locating Rear Seat Shoulder Belt Guide RH

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   2. Remove the rear seat belt from the rear seat shoulder belt guide center.
      Fig 6: Locating Rear Seat Shoulder Belt

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Remove the bolt, 2 nuts and the rear seatback assembly RH.
   Fig 7: Identifying Rear Seatback Assembly RH

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002