FRONT SEAT ASSEMBLY (for Manual Seat): Removal

CAUTION:

Always wear safety gloves because the edges of the seatback frame and seat adjuster are sharp and may cause injury.
Work must be started more than 90 seconds after the ignition switch is turned off and the negative (-) terminal cable is disconnected from the battery.
(The SRS is equipped with a back-up power source. If work is started within 90 seconds after disconnecting the negative (-) terminal cable of the battery, the SRS may deploy.)

HINT:

Installation is in the reverse order of removal. However, special points concerning installation are indicated.
Use the same procedures for the RH side and LH side.

DISCONNECT BATTERY NEGATIVE TERMINAL
HINT:

See AIRBAG SYSTEM
REMOVE SEAT TRACK BRACKET COVER OUTER FRONT RH
1. Disengage the 2 claws and remove the seat track bracket cover outer front RH.
REMOVE SEAT TRACK BRACKET COVER INNER FRONT RH
1. Disengage the 2 claws and remove the seat track bracket cover inner front RH.
REMOVE FRONT SEAT TRACK COVER RH REAR OUTER
1. Disengage the 2 claws and remove the front seat track cover RH rear outer.
REMOVE SEAT TRACK BRACKET COVER INNER RH
1. Disengage the 2 claws and remove the seat track bracket cover inner RH.
REMOVE FRONT RH SEAT ASSEMBLY
1. Remove the 4 bolts.
2. Disconnect the connectors and clamp.
3. Remove the front RH seat assembly.