Front Bumper: Removal

1. Remove the 2 bolts and clip.
2. Disengage the 5 claws and remove the radiator grille sub-assembly.

Fig 1: Identifying Radiator Grille Sub-Assembly Claws

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Turn the pin hold clip 90° as shown in the illustration and remove it. (LH side)

   HINT:

   Remove the RH side by following the same procedure as for the LH side.

   Fig 2: Turning Pin Hold Clip

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 2 bolts, 10 screws and 2 clips.
   Fig 3: Identifying Front Bumper Assembly Bolts, Screws And Clips

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Disengage the 4 claws by pulling the left side of the front bumper cover in the direction shown by the arrow. (LH side)

   HINT:

   Disengage the RH side by following the same procedure as for the LH side.

   Fig 4: Identifying Front Bumper Cover Claws

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Disconnect the fog light connector (w/fog light) and remove the front bumper assembly.

1. Remove the screw.
2. Disengage the 2 claws and remove the front bumper stay No.2 LH.
   Fig 5: Identifying Front Bumper Stay No. 2 Claws And Screw

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Removal of the front bumper stay No.2 RH is the same as the front bumper stay No.2 LH.

1. Remove the front bumper energy absorber.

Fig 6: Identifying Front Bumper Energy Absorber

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 6 bolts and the front bumper reinforcement.

Fig 7: Identifying Front Bumper Reinforcement Bolts

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

See REMOVAL