Inspection Procedure

1. Connect the intelligent tester to the DLC3.
2. Turn the power switch ON (IG).
3. Turn the intelligent tester ON.
4. Enter the following menus: DIAGNOSIS / OBD/MOBD / HV ECU / DTC INFO / CURRENT CODES.
5. Read DTCs.

   Result: DTC P3000 (INF 389) and other DTCs are output 

   HINT:

   If any other codes besides P3000 (INF 389) are output, perform troubleshooting for those DTCs first.

YES : GO TO RELEVANT  DIAGNOSTIC TROUBLE CODE CHART 

NO : GO TO NEXT STEP 

1. Turn the power switch ON (READY).
2. Check if the engine starts.

   OK : The engine starts 

NG : REPLACE HV SUPPLY BATTERY ASSEMBLY 

OK : LEAVE VEHICLE IN P POSITION, AND CHARGE HV BATTERY IN IDLE STATUS UNTIL IDLING STOPS