Inspection Procedure

HINT:

After repairing the malfunction, restart the system (to turn the READY light ON) and recheck the DTCs.

1. READ OUTPUT DTC (HV BATTERY) 
   1. Connect the intelligent tester to the DLC3.
   2. Turn the power switch ON (IG).
   3. Turn the intelligent tester ON.
   4. Enter the following menus: DIAGNOSIS / OBD/MOBD / HV BATTERY / DTC INFO / TROUBLE CODES.
   5. Read DTCs.

      Result: DTCs are output 

   YES : GO TO RELEVANT  DIAGNOSTIC TROUBLE CODE CHART 

   NO : REPLACE BATTERY ECU ASSEMBLY