Headlight Dimmer Switch: Inspection
- INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY
- Inspect the light control switch.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
LIGHT CONTROL SWITCH RESISTANCETester Connection Condition Specified Condition 12 - 18 OFF 10 k or higher 12 - 19 12 - 20 12 - 18 TAIL Below 1 12 - 18
12 - 20HEAD Below 1 12 - 19 AUTO Below 1 If the result is not as specified, replace the switch assembly.
- Measure the resistance according to the value(s) in the table below.
- Inspect the headlight dimmer switch.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
HEADLIGHT DIMMER SWITCH RESISTANCETester Connection Condition Specified Condition 11 - 12 FLASH Below 1 11 - 17 12 - 16 LOW BEAM Below 1 11 - 12 HIGH BEAM Below 1 If the result is not as specified, replace the switch assembly.
- Measure the resistance according to the value(s) in the table below.
- Inspect the turn signal switch.
- Measure the resistance according to the value(s) in the table below.
Standard resistance
TURN SIGNAL SWITCH RESISTANCETester Connection Condition Specified Condition 12 - 13 Right turn Below 1 12 - 13 Neutral 10 k or higher 12 - 15 12 - 15 Left turn Below 1 If the result is not as specified, replace the switch assembly.
- Measure the resistance according to the value(s) in the table below.
- Inspect the fog light switch.
- Inspect the light control switch.