How To Proceed With Troubleshooting

The hand-held tester can be used at step  3,  6,  9,  12.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: GO TO NEXT STEP. 

2. CUSTOMER PROBLEM ANALYSIS (SEE  CUSTOMER PROBLEM ANALYSIS CHECK  ) 

   NEXT: GO TO NEXT STEP. 

3. CHECK AND CLEAR DTCS AND FREEZE FRAME DATA (SEE  DTC CHECK/CLEAR   AND  FREEZE FRAME DATA OF ABS  ) 

   NEXT: GO TO NEXT STEP. 

4. PROBLEM SYMPTOM CONFIRMATION 
   1. SYMPTOM DOES NOT OCCUR: GO TO STEP 5 
   2. SYMPTOM OCCURS: GO TO STEP   6 
5. SYMPTOM SIMULATION (SEE ELECTRONIC CIRCUIT INSPECTION PROCEDURE  ) 

   NEXT: GO TO NEXT STEP. 

6. DTC CHECK (SEE  DTC CHECK/CLEAR  ) 
   1. THERE IS NO OUTPUT: GO TO STEP 7 
   2. THERE IS OUTPUT: GO TO STEP   8 
7. PROBLEM SYMPTOMS TABLE (SEE  PROBLEM SYMPTOMS TABLE  ) 

   CHECK FOR FLUID LEAKAGE AND GO TO STEP   10 

8. DTC CHART (SEE  DIAGNOSTIC TROUBLE CODE CHART  ) 

   NEXT: GO TO NEXT STEP. 

9. CIRCUIT INSPECTION (SEE  DTC C0200/31 RIGHT FRONT SPEED SENSOR CIRCUIT, DTC C0205/32 LEFT FRONT SPEED SENSOR CIRCUIT DTC, C1235/35 FOREIGN MATTER IS ATTACHED ON TIP OF RIGHT FRONT SENSOR DTC C1236/36 FOREIGN MATTER IS ATTACHED ON TIP OF LEFT FRONT SENSOR   TO  TS TERMINAL CIRCUIT  ) 

   HINT:

   When 2 or more DTCs are recorded, and the problem is not identified, perform circuit inspection of the other DTCs.

   NEXT: GO TO NEXT STEP. 

10. IDENTIFICATION OF PROBLEM 

    NEXT: GO TO NEXT STEP. 

11. REPAIR 

    NEXT: GO TO NEXT STEP. 

12. CONFIRMATION TEST 

    NEXT: GO TO NEXT STEP. 

    END