Torque Specifications: 1ZZ-FE:

WARNING: This page is about a different car, the 2005 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.

Torque Specifications - 1ZZ-FE

Part Tightened		N.m	kgf.cm	ft.lbf
Battery negative terminal x Battery		5.4	55	48 in..lbf
Engine hanger x Cylinder head sub-assy		38	387	28
Radio setting condenser x Cylinder head sub-assy		10	102	7
Engine coolant temperature sensor x Cylinder head sub-assy		19.6	200	14
Exhaust manifold x Cylinder head sub-assy		37	377	27
Exhaust manifold heat insulator No. 1 x Exhaust manifold		18	184	13
Manifold stay x Exhaust manifold		49	500	36
Manifold stay x Cylinder block sub-assy		49	500	36
Knock sensor x Cylinder block sub-assy		20	205	15
Crankshaft position sensor x Timing chain or belt cover		9.0	92	80 in..lbf
Camshaft position sensor x Cylinder head sub-assy		9.0	92	80 in..lbf
Water by-pass pipe No. 1 x Cylinder block sub-assy		9.0	92	80 in..lbf
Water by-pass pipe No. 1 x Cylinder head sub-assy		9.0	92	80 in..lbf
Oil level gage guide x Water by-pass pipe No. 1		13	133	10
Engine mounting bracket rear x Engine mounting insulator rear		65	663	48
Engine mounting bracket front x Engine mounting insulator front		52	530	38
Engine mounting bracket LH x Engine mounting insulator LH		80	816	59
Engine mounting bracket RH x Engine mounting insulator RH		52	530	38
Front suspension crossmember sub-assy x Body (Seepage 14-21)	Front	113	1,152	83
	Rear	157	1,601	116
Center member x Body		60	612	44
Return tube sub-assy x Body (See page 14-21)	Bolt A	5.0	51	44 in..lbf
	Bolt B	7.8	80	69 in..lbf
Air cleaner case x Body		7.0	71	62 in..lbf
Air cleaner case x Engine mounting bracket LH		7.0	71	62 in..lbf
Battery carrier x Body		12.8	131	9
Battery clamp sub-assy x Body		5.0	51	44 in..lbf
Battery clamp sub-assy x Battery clamp bolt		3.5	36	31 in..lbf
Front wheel RH & LH x Front axle hub sub-assy RH & LH		103	1,050	76
Oil strainer sub-assy x Crankshaft bearing cap sub-assy		9.0	92	80 in..lbf
Oil pan sub-assy x Crankshaft bearing cap sub-assy		9.0	92	80 in..lbf
Oil pan drain plug x Oil pan sub-assy		37	377	27
Oil filter union x Crankshaft bearing cap sub-assy		30	306	22
Oil filter sub-assy x Oil filter union		13	133	10
Cylinder head sub-assy x Cylinder block sub-assy (See page 14-36)	1st	49	500	36
	2nd	Turn 90°	Turn 90°	Turn 90°
Camshaft timing gear assy x Camshaft		54	551	40
Camshaft timing gear or sprocket x No. 2 Camshaft		54	551	40
Camshaft bearing cap No. 1 x Cylinder head sub-assy		23	235	17
Camshaft bearing cap No. 3 x Cylinder head sub-assy		13	133	10
Oil control valve filter x Cylinder head sub-assy		30	306	22
Camshaft timing oil control valve assy x Cylinder head sub-assy		9.0	92	80 in..lbf
Oil pump assy x Cylinder block sub-assy		9.0	92	80 in..lbf
Chain vibration damper No. 1 x Cylinder head sub-assy		9.0	92	80 in..lbf
Chain vibration damper No. 1 x Cylinder block sub-assy		9.0	92	80 in..lbf
Chain tensioner slipper x Cylinder block sub-assy		18.5	189	14
Stud bolt x Timing chain cover sub-assy		5.0	51	44 in..lbf
Timing chain or belt cover sub-assy x Cylinder head sub-assy		13	133	10

TORQUE SPECIFICATIONS

Part Tightened	N.m	kgf.cm	ft.lbf
Timing chain or belt cover sub-assy at Cylinder block sub-assy (See OVERHAUL ) A	13	133	10
Timing chain or belt cover sub-assy at Cylinder block sub-assy (See OVERHAUL ) B	18.5	189	14
Chain tensioner assy No. 1 at Timing chain or belt cover sub-assy	9.0	92	80 in.lbf
Crankshaft pulley at Crankshaft	138	1,407	102
Water pump assy at Timing chain cover sub-assy (See OVERHAUL ) A	9.0	92	80 in.lbf
Water pump assy at Timing chain cover sub-assy (See OVERHAUL ) B	11	112	8
Engine mounting bracket at Timing chain or belt cover sub-assy	47	479	35
Cylinder head cover sub-assy at Cylinder head sub-assy (See OVERHAUL ) A	11	112	8
Cylinder head cover sub-assy at Cylinder head sub-assy (See OVERHAUL ) B	9.0	92	80 in.lbf
Cylinder head cover sub-assy at Timing chain or belt cover sub-assy	11	112	8
Spark plug at Cylinder head sub-assy	25	255	18
Ventilation valve sub-assy at Cylinder head cover sub-assy	30	306	22
V-ribbed belt tensioner assy at Cylinder head sub-assy	29	296	21
V-ribbed belt tensioner assy at Cylinder block sub-assy	69	704	51
Ignition coil assy at Cylinder head cover sub-assy	9.0	92	80 in.lbf
Engine wire at Cylinder head cover sub-assy	9.0	92	80 in.lbf
Engine mounting insulator RH at Body	52	530	38
Engine mounting insulator RH at Engine mounting bracket	52	530	38
Oil reservoir bracket No. 1 at Body	7.8	80	69 in.lbf
Cylinder head cover No. 2 at Cylinder head cover sub-assy	7.0	71	62 in.lbf
Intake manifold at Cylinder head sub-assy	30	306	22
Drive plate & ring gear sub-assy at Crankshaft	88	897	65
Flywheel sub-assy at Crankshaft (see ENGINE REAR OIL SEAL (1ZZ-FE) ) 1st	49	500	36
Flywheel sub-assy at Crankshaft (see ENGINE REAR OIL SEAL (1ZZ-FE) ) 2nd	Turn 90°	Turn 90°	Turn 90°
Stud bolt at Cylinder head sub-assy (See OVERHAUL )A, D and E	9.5	97	84 in.lbf
Stud bolt at Cylinder head sub-assy (See OVERHAUL )B and C	5.0	51	44 in.lbf
Connecting rod cap at Connecting rod (See OVERHAUL ) 1st	20	204	15
Connecting rod cap at Connecting rod (See OVERHAUL ) 2nd	Turn 90°	Turn 90°	Turn 90°
Crankshaft bearing cap sub-assy at Cylinder block sub-assy (See OVERHAUL ) 1st	44	449	33
Crankshaft bearing cap sub-assy at Cylinder block sub-assy (See OVERHAUL ) 2nd	Turn 90°	Turn 90°	Turn 90°
Crankshaft bearing cap sub-assy at Cylinder block sub-assy (See OVERHAUL ) Others	19	194	14
Stud bolt at Cylinder block sub-assy (See OVERHAUL ) A, C and D	5.0	51	44 in.lbf
Stud bolt at Cylinder block sub-assy (See OVERHAUL ) B	11	112	8
Stud bolt at Cylinder block sub-assy (See OVERHAUL ) E	9	92	80 in.lbf
Cylinder block water drain cock sub-assy at Cylinder block sub-assy	25	255	18
W/Head taper screw plug No. 2 at Cylinder head sub-assy	44	449	33