How To Proceed With Troubleshooting

HINT:

The hand-held tester can be used at steps 3, 6, 9, 12.

1. Vehicle Brought to Workshop 
2. CUSTOMER PROBLEM ANALYSIS CHECK  
3. Check and Clear DTCs and Freeze Frame Data (See  PRE-CHECK  ) 
4. Problem Symptom Confirmation 

   Symptom does not occur: Go to step 5 

   Symptom occurs: Go to step 6 

5. Symptom Simulation (See  ELECTRONIC CIRCUIT INSPECTION PROCEDURE  ) 
6. DTC Check (See  PRE-CHECK  ) 

   There is no output: Go to step 7 

   There is output: Go to step 8 

7. PROBLEM SYMPTOMS TABLE  

   Check for fluid leakage and Go to step 10 

8. DIAGNOSTIC TROUBLE CODE CHART  
9. CIRCUIT DESCRIPTION - RIGHT FRONT SPEED SENSOR  

   HINT:

   When 2 or more DTCs are detected, perform circuit inspection one by one until the problem is identified.

10. Identification of Problem 
11. Repair 
12. Confirmation Test 

End