LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2006 >> Camry Base, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Brakes - Abs With EBD & BA & TRAC & VSC (Diagnostics) >> Data List/Active Test

Data List/Active Test

  1. DATA LIST 

    HINT:

    According to the DATA LIST displayed on the hand-held tester, you can read the value and status of the switch, sensor, actuator and so on without parts removal. Reading the DATA LIST as the first step of troubleshooting is one of the methods to shorten labor time.

    1. Connect the hand-held tester to the DLC3.
    2. Turn the ignition switch ON.
    3. From the display on the tester, read the "DATA LIST".
    DATA LIST REFERENCE TABLE

    Item Measurement Item / Range (Display) Normal Condition Diagnostic Note
    ABS MOT RELAY ABS motor relay / ON or OFF ON: Motor relay ON
    OFF: Motor relay OFF
    -
    SOL RELAY Solenoid relay / ON or OFF ON: Solenoid relay ON
    OFF: Motor relay OFF
    -
    VSC / TRC OFF SW TRAC control switch / ON or OFF ON: TRAC control switch
    ON
    OFF: TRAC control switch
    OFF
    -
    AIR BLD SUPPORT Air bleed support / ON or OFF ON: Support ON
    OFF: Support OFF
    -
    IDLE SW Main idle switch / ON or OFF ON: Accelerator pedal released
    OFF: Accelerator pedal depressed
    -
    STOP LIGHT SW Stop lamp switch / ON or OFF ON: Brake pedal depressed
    OFF: Brake pedal released
    -
    PKB SW Parking brake switch / ON or OFF ON: Parking brake applied
    OFF: Parking brake released
    -
    ABS OPERT FR ABS operation (FR) / BEFORE or OPERATE BEFORE: No ABS operation (FR)
    OPERATE: During ABS operation (FR)
    -
    ABS OPERT FL ABS operation (FL) / BEFORE or OPERATE BEFORE: No ABS operation (FL)
    OPERATE: During ABS operation (FL)
    -
    ABS OPERT RR ABS operation (RR) / BEFORE or OPERATE BEFORE: No ABS operation (RR)
    OPERATE: During ABS operation (RR)
    -
    ABS OPERT RL ABS operation (RL) / BEFORE or OPERATE BEFORE: No ABS operation (RL)
    OPERATE: During ABS operation (RL)
    -
    WHEEL SPD FR Wheel speed sensor (FR) reading / min.: 0 km/h (0 MPH), max.: 326 km/h (202 MPH) Actual wheel speed Similar speed as indicated on speedometer
    WHEEL SPD FL Wheel speed sensor (FL) reading / min.: 0 km/h (0 MPH), max.: 326 km/h (202 MPH) Actual wheel speed Similar speed as indicated on speedometer
    WHEEL SPD RR Wheel speed sensor (RR) reading / min.: 0 km/h (0 MPH), max.: 326 km/h (202 MPH) Actual wheel speed Similar speed as indicated on speedometer
    WHEEL SPD RL Wheel speed sensor (RL) reading / min.: 0 km/h (0 MPH), max.: 326 km/h (202 MPH) Actual wheel speed Similar speed as indicated on speedometer
    DECELERAT SENS Deceleration sensor 1 reading / min.: -1.869 G, max.: 1.869 G Approximately 0 +/- 0.13G at a stationary condition Reading changes when vehicle is bounced
    DECELERAT SENS2 Deceleration sensor 2 reading / min.: -1.869 G, max.: 1.869 G Approximately 0 +/- 0.13G at a stationary condition Reading changes when vehicle is bounced
    IG VOLTAGE ECU power supply voltage / TOO LOW / NORMAL TOO HIGH: 14 V or over
    NORMAL: 9.5 V to 14 V
    TOO LOW: Below 9.5 V
    -
    SFRR ABS solenoid (SFRR) / ON or OFF ON: Operate
    OFF: Not operate
    -
    SFRH ABS solenoid (SFRH) / ON or OFF ON: Operate
    OFF: Not operate
    -
    SFLR ABS solenoid (SFLR) / ON or OFF ON: Operate
    OFF: Not operate
    -
    SFLH ABS solenoid (SFLH) / ON or OFF ON: Operate
    OFF: Not operate
    -
    SRRR (SRR) ABS solenoid (SRRR (SRR)) / ON or OFF ON: Operate
    OFF: Not operate
    -
    SRRH (SRH) ABS solenoid (SRRH (SRH)) / ON or OFF ON: Operate
    OFF: Not operate
    -
    SRLR ABS solenoid (SRLR) / ON or OFF ON: Operate
    OFF: Not operate
    -
    SRLH ABS solenoid (SRLH) / ON or OFF ON: Operate
    OFF: Not operate
    -
    SMF (BA-SOL) TRAC solenoid (SMF) / ON or OFF ON: Operate
    OFF: Not operate
    -
    SMR TRAC solenoid (SMR) / ON or OFF ON: Operate
    OFF: Not operate
    -
    THROTTLE Throttle position sensor/Min.: 0 deg, Max.: 125 deg Release accelerator pedal:
    Approx. 0 deg.
    Depress accelerator pedal:
    Approx. 90 deg.
    -
    ENGINE SPD Engine Speed/Min.: 0 rpm, Max.: 6,000 rpm Actual engine speed -
    VEHICLE SPD Maximum wheel speed sensor reading / min.: 0 km/h (0 MPH), max.: 326 km/h (202 MPH) Actual vehicle speed Similar speed as indicated on speedometer
    YAW RATE Yaw rate sensor/Min.: -128 deg/s, Max.: 128 deg/s Min.: -128 deg/s
    Max.: 128 deg/s
    -
    YAW ZERO VALUE Memorized zero value/Min.: -128 deg/s, Max.: 128 deg/s Min.: -128 deg/s
    Max.: 128 deg/s
    -
    STEERING ANG Steering sensor/Min.: -1152 deg, Max.: 1150.875 deg Left turn: Increase
    Right turn: Decrease
    -
    MAS CYL PRS 1 Master cylinder pressure sensor 1 reading / min.: 0 V, max.: 5 V When brake pedal is released: 0.3 to 0.9 V Reading increases when brake pedal is depressed
    TEST MODE Test mode / NORMAL or TEST NORMAL: Normal mode
    TEST: During test mode
    -
    #CODES Number of DTC recorded / min.: 0, max.: 255 Min.: 0, max.: 39 -
    SPD SEN FR FR speed sensor open detection / OPEN or NORMAL OPEN: Momentary interruption -
    SPD SEN FL FL speed sensor open detection / OPEN or NORMAL OPEN: Momentary interruption -
    SPD SEN RR RR speed sensor open detection / OPEN or NORMAL OPEN: Momentary interruption -
    SPD SEN RL RL speed sensor open detection / OPEN or NORMAL OPEN: Momentary interruption -
    YAWRATE SEN Yaw rate sensor open detection OPEN: Momentary interruption -
    DECELE SEN G sensor open detection OPEN: Momentary interruption -
    STEERING SEN Steering sensor open detection OPEN: Momentary interruption -
    M/C SEN 1 Master Cylinder pressure sensor 1 open detection OPEN: Momentary interruption -
    EFI COM EFI communication open detection OPEN: Momentary interruption -
  2. ACTIVE TEST 

    HINT:

    Performing the ACTIVE TEST using the hand-held tester allows the relay and actuator, etc. to operate without removing any parts. Performing the ACTIVE TEST as the first step of troubleshooting is one of the methods to shorten labor time.

    It is possible to display the DATA LIST during the ACTIVE TEST.

    1. Connect the hand-held tester to the DLC3.
    2. Turn the ignition switch to the ON position.
    3. According to the display on the tester, perform the "ACTIVE TEST".

    HINT:

    The ignition switch must be turned to the ON position to proceed to the ACTIVE TEST using the hand-held tester.

    ACTIVE TEST

    Item Vehicle Condition / Test Details Diagnostic Note
    SFRR Turns ABS solenoid (SFRR) ON / OFF Operation of solenoid (clicking sound) can be heard
    SFRH Turns ABS solenoid (SFRH) ON / OFF Operation of solenoid (clicking sound) can be heard
    SFLR Turns ABS solenoid (SFLR) ON / OFF Operation of solenoid (clicking sound) can be heard
    SFLH Turns ABS solenoid (SFLH) ON / OFF Operation of solenoid (clicking sound) can be heard
    SRRR Turns ABS solenoid (SRRR) ON / OFF Operation of solenoid (clicking sound) can be heard
    SRRH Turns ABS solenoid (SRRH) ON / OFF Operation of solenoid (clicking sound) can be heard
    SRLR Turns ABS solenoid (SRLR) ON / OFF Operation of solenoid (clicking sound) can be heard
    SRLH Turns ABS solenoid (SRLH) ON / OFF Operation of solenoid (clicking sound) can be heard
    SMF (BA-SOL) Turns TRAC solenoid SMF (BA-SOL) ON / OFF Operation of solenoid (clicking sound) can be heard
    SMR Turns TRAC solenoid SMR ON / OFF Operation of solenoid (clicking sound) can be heard
    SFRR & SFRH Turns ABS solenoid SFRR & SFRH ON / OFF Operation of solenoid (clicking sound) can be heard
    SFLR & SFLH Turns ABS solenoid SFLR & SFLH ON / OFF Operation of solenoid (clicking sound) can be heard
    SRH & SRR Turns ABS solenoid SRH & SRR ON / OFF Operation of solenoid (clicking sound) can be heard
    SRLR & SRLH Turns ABS solenoid SRLR & SRLH ON / OFF Operation of solenoid (clicking sound) can be heard
    SFRH & SFLH Turns ABS solenoid SFRH & SFLH ON / OFF Operation of solenoid (clicking sound) can be heard
    SOL RELAY Turns ABS solenoid relay ON / OFF Operation of solenoid (clicking sound) can be heard
    ABS MOT RELAY Turns ABS motor relay ON / OFF Operation sound of motor can be heard
    ABS WARN LIGHT Turns ABS warning light ON / OFF Observe combination meter
    VSC WARN LIGHT Turns VSC warning light ON / OFF Observe combination meter
    VSC / TRAC OFF IND Turns VSC / TRAC OFF indicator ON / OFF Observe combination meter
    SLIP INDI LIGHT Turns SLIP indicator light ON / OFF Observe combination meter
    BRAKE WRN LIGHT Turns BRAKE warning light ON / OFF Observe combination meter
    VSC / BR WARN BUZ Turns VSC / BRAKE warning buzzer ON / OFF Buzzer can be heard