LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2006 >> Camry Base, Automatic >> Repair and Diagnosis >> Brakes >> Anti-Lock Brakes >> Brakes - Abs With EBD (DENSO Made) (Diagnostics) >> TS Terminal Circuit >> Inspection Procedure

Inspection Procedure

  1. INSPECT DLC3 (TS TERMINAL) 
    1. Turn the ignition switch to the ON position.
    2. Measure the voltage according to the value(s) in the table below.
      Fig 1: Identifying DLC3 Connector Terminals
      G04067685Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard: 

    DLC3 CONNECTOR TERMINALS - VOLTAGE TABLE

    Tester Connection Condition Specified Condition
    D3-12 (Ts) - D3-4 (CG) IG switch ON 10 to 14 V

    NG: Go to step 3 

    OK: Go to next step 

  2. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3) 
    1. Check the harness and connector between the skid control ECU and DLC3.

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (TS CIRCUIT) 

    OK: CHECK AND REPLACE BRAKE ACTUATOR ASSY (See  REPLACEMENT  ) 

  3. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND) 
    1. Measure the resistance according to the value(s) in the table below.
      Fig 2: Identifying DLC3 Connector Terminals
      G04067685Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard: 

    DLC3 - BODY GROUND - RESISTANCE TABLE

    Tester Connection Specified Condition
    D3-4 (CG) - Body ground Below 1 Ω

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (GND CIRCUIT) 

    OK: Go to next step 

  4. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - DLC3) 
    1. Check the harness and connector between the skid control ECU and DLC3.

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (TC CIRCUIT) 

    OK: CHECK AND REPLACE BRAKE ACTUATOR ASSY (See  REPLACEMENT  ) 

scientia non olet · About LEMON Manuals