Inspection Procedure

HINT:

Start the inspection from step 1 in case of using the hand-held tester and start from step 2 in case of not using the hand-held tester.

1. PERFORM ACTIVE TEST BY HAND-HELD TESTER (ABS SOLENOID RELAY OPERATION) 
   1. Select the "ABS SOL RELAY" in the ACTIVE TEST and operate the ABS solenoid relay on the hand- held tester.
   2. Check the operation sound of the ABS solenoid relay when operating it with the hand-held tester.

      OK: 

      The operation sound of the ABS solenoid should be heard. 

   OK: CHECK AND REPLACE BRAKE ACTUATOR ASSY (See  REPLACEMENT  ) 

   NG: Go to next step 

2. CHECK TERMINAL VOLTAGE (+BS AND GND OF SKID CONTROL ECU) 
   1. Disconnect the skid control ECU connector.
   2. Measure the voltage between terminals 1 and 2 or 24 of the skid control ECU connector.

      Standard: 

      11 to 14 V 

   Fig 1: Measuring Voltage Between Skid Control ECU Connector Terminals 1, 2 Or 24

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NG: CHECK AND REPAIR HARNESS AND CONNECTOR 

   OK: IF THE SAME CODE IS STILL OUTPUT AFTER THE DTC IS DELETED, CHECK THE CONTACT CONDITION OF EACH CONNECTION