Circuit Description
This relay supplies power to each ABS solenoid. After the ignition switch is turned ON, if the initial check is OK, the relay turns on.
DTC REFERENCE TABLE
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C0278/11 | Condition 1. or 2. continues for 0.2 sec. or more:
|
|
| C0279/12 | Immediately after IG switch has been turned ON, the solenoid relay is OFF.*2 |
*1 Solenoid relay contact ON condition:
All of the solenoid terminal voltage is half of IG terminal voltage or more.
*2 Solenoid relay contact OFF condition:
All of the solenoid terminal voltage is half of IG terminal voltage or less.