Typical Enabling Conditions
Misfire:
TYPICAL ENABLING CONDITIONS
| The monitor will run whenever these DTCs are not present | P0100, P0101, P0102, P0103 (MAF Sensor), P0110, P0112, P0113 (IAT Sensor), P0115, P0116, P0117, P0118 (ECT Sensor), P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135 (TP Sensor), P0125 (Insufficient ECT for Closed Loop), P0327, P0328, P0332, P0333 (Knock Sensor), P0335 (CKP Sensor), P0340, P0342, P0343, P0345 (VVT Sensor 1,2), P0500 (VSS), |
| Battery voltage | 8 V or more |
| VVT system | No operate by scan tool |
| Engine RPM | 400 to 6,500 rpm |
| All of following conditions met | Condition 1 and 2 |
| 1. Engine Coolant Temperature (ECT) | -10°C (14°F) or more |
| 2. Either of following conditions met | Condition (a) or (b) |
| (a) Engine start ECT | More than -7°C (19°F) |
| (b) ECT | More than 20°C (68°F) |
| Fuel-cut | OFF |
Monitor period of emission-related-misfire:
MONITOR PERIOD OF EMISSION-RELATED-MISFIRE REFERENCE
| First 1,000 revolutions after engine start, or check mode | Crankshaft 1,000 revolutions |
| Except above | Crankshaft 1,000 revolutions x 4 |
Monitor period of catalyst-damage-misfire (MIL blinks):
MONITOR PERIOD OF CATALYST-DAMAGE-MISFIRE REFERENCE
| All of following conditions 1, 2 and 3 are met | Crankshaft 200 revolutions |
| 1. Driving cycle | 1st |
| 2. Check mode | OFF |
| 3. Engine RPM | Less than 2,600 rpm |
| Except above | Crankshaft 200 revolutions x 3 |