LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2005 >> RAV4 Base, AWD, Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> Brakes - Abs With EBD & BA & TRAC & VSC (Diagnostics) >> Problem Symptoms Table

Problem Symptoms Table

If a normal code is indicated during the DTC check but the problem still occurs, check the circuits for each problem symptom in the order given in the table below.

NOTE:
  • When replacing brake actuator assembly, sensor or etc., turn the ignition switch OFF.
  • When replacing yaw rate sensor and/or the brake actuator assembly, make sure to perform yaw rate sensor zero point calibration (see PRE-CHECK ).
PROBLEM SYMPTOMS TABLE - ABS, VSC AND BRAKE ASSIST SYSTEMS

Symptoms Suspected Area
ABS does not operate
  1. Check the DTC that the normal code is output.
  2. IG power source circuit
  3. Speed sensor circuit
  4. Check the hydraulic circuit for leakage.
  5. When 1. to 4. are all normal and the problem still occurs, replace the brake actuator assembly.
ABS does not operate efficiently
  1. Check the DTC that the normal code is output.
  2. Speed sensor circuit
  3. Stop light switch circuit
  4. Check the hydraulic circuit for leakage.
  5. When 1. to 4. are all normal and the problem still occurs, replace the brake actuator assembly.
ABS warning light abnormal
  1. ABS warning light circuit
  2. Brake actuator assembly
BRAKE warning light abnormal
  1. BRAKE warning light circuit
  2. Brake actuator assembly
DTC check cannot be done
  1. ABS warning light circuit
  2. TC terminal circuit
  3. VSC warning light circuit
  4. When 1. and 3. are all normal and the problem still occurs, replace the brake actuator assembly.
Speed sensor signal check cannot be done
  1. Brake actuator assembly
VSC does not operate TRAC does not operate
  1. Check the DTC, reconfirming that the normal code is output.
  2. Perform zero point calibration
  3. IG power source circuit
  4. Check the hydraulic circuit for leakage
  5. Speed sensor circuit
  6. Yaw rate sensor circuit
  7. Steering angle sensor circuit
  8. When 1. to 7. are all normal and the problem still occurs, replace the brake actuator assembly.
VSC does not operate efficiently TRAC does not operate efficiently
  1. Check the DTC, reconfirming that the normal code is output.
  2. Perform zero point calibration
  3. Check the hydraulic circuit for leakage
  4. Speed sensor circuit
  5. Yaw rate sensor circuit
  6. Steering angle sensor circuit
  7. When 1. to 6. are all normal and the problem still occurs, replace the brake actuator assembly.
VSC warning light abnormal
  1. VSC warning light circuit
  2. Brake actuator assembly
SLIP indicator light abnormal
  1. SLIP indicator light circuit
  2. Brake actuator assembly
TRAC OFF indicator abnormal
  1. TRAC OFF indicator light circuit
  2. TRAC OFF switch circuit
  3. Brake actuator assembly
scientia non olet · About LEMON Manuals