Rear Brake Caliper: Removal

Remove the union bolt and gasket from the caliper, then disconnect the flexible hose from the caliper. Use a container to catch brake fluid as it drains out.

Torque: 30 N.m (310 kgf.cm, 22 ft.lbf) 

HINT:

At the time of installation, please refer to the following item. Install the flexible hose lock securely in the lock hole in the caliper.

Fig 1: Removing Union Bolt

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Hold the sliding pin and loosen the 2 installation bolts.

   Torque: 26 N.m (270 kgf.cm, 20 ft.lbf) 

2. Remove the 2 installation bolts.
3. Remove the caliper from the torque plate.