LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2005 >> ECHO 2D Sedan, Standard >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Supplemental Restraint System >> SIDE AIRBAG SENSOR ASSEMBLY (2-Door) >> Removal

SIDE AIRBAG SENSOR ASSEMBLY (2-Door): Removal

NOTE: Do not open the cover or the case of the ECU and various electrical devices unless absolutely necessary.
(If the IC terminals are touched, the IC may be destroyed by static electricity.)
NOTE: For step 1 to 8, refer to SEAT BELT PRETENSIONER (SEDAN) .
  1. REMOVE FRONT DOOR SCUFF PLATE 
  2. REMOVE FRONT DOOR OPENING TRIM 
  3. REMOVE REAR SEAT CUSHION 
  4. REMOVE REAR SEATBACK 
  5. REMOVE REAR SEATBACK HINGE 
  6. REMOVE REAR SEAT BELT 
  7. REMOVE QUARTER TRIM 
  8. REMOVE RETRACTOR PART OF FRONT SEAT OUTER BELT 
  9. REMOVE SIDE AIRBAG SENSOR ASSEMBLY 
    1. Disconnect the connector.
      NOTE: Remove the connector with the sensor assembly installed.
    2. Remove the 3 bolts and side airbag sensor assembly.
    Fig 1: Removing Bolts And Side Airbag Sensor Assembly
    G02575904Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals