Inspection Procedure

WARNING: This page is about a different variant/trim than selected.

Check transmission wire
PREPARATION:

Disconnect the transmission wire connector.

CHECK:

Measure resistance between SL of transmission wire and body ground.

OK:
1. Resistance: 11 to 15 Ω at 20°C (68°F)
1. NG: Go to 3
2. OK: Go to next step
Measure resistance between terminals SL of ECM and body ground.
PREPARATION:
1. Connect the transmission wire connector.
2. Disconnect the ECM connector.
CHECK:

Measure resistance between terminals SL of ECM connector and body ground.

OK:
1. Resistance: 11 to 15 Ω at 20°C (68°F)
1. NG: Repair or replace the harness or connector ( HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE ).
  
  Fig 1: Identifying Terminal SL Of ECM Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. OK: Replace the ECM.
Check shift solenoid valve SL operation.
PREPARATION:
1. Jack up the vehicle.
2. Remove the oil pan.
3. Remove the shift solenoid valve SL.
CHECK:
1. Measure resistance between terminal SL of shift solenoid valve and solenoid body.
2. Connect positive (+) lead to terminal of solenoid connector, negative (-) lead to solenoid body.
OK:
1. (a) Resistance: 11 to 15 Ω at 20°C (68°F)
2. (b) The shift solenoid valve SL makes operation noise.
1. NG: Replace the shift solenoid valve SL.
  
  Fig 2: Checking Shift Solenoid Valve SL Operation
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. OK: Repair or replace the transmission wire ( ATF TEMPERATURE SENSOR ).