Transaxle Specifications
WARNING: This page is about a different variant/trim than selected.
TRANSAXLE SPECIFICATIONS
| Application | In. (mm) | |
|---|---|---|
| Bushing Inside Diameter (Maximum) | ||
| Oil Pump Body | 1.501 (38.14) | |
| Oil Pump Stator Shaft | .847 (21.53) | |
| Input Shaft End Play | .015-.051 (.37-1.29) | |
| Oil Pump | ||
| Driven Gear-To-Body Clearance | .004-.006 (.10-.15) | |
| Driven Gear Tip-To-Cresent Clearance | .003-.006 (.07-.15) | |
| Gear Side Clearance | .0008-.0020 (.020-.050) | |
| Pack Clearance | ||
| Direct Clutch | .024-.040 (.62-1.02) | |
| Forward Clutch | .055-.071 (1.40-1.81) | |
| Reverse Clutch | .034-.050 (.86-1.26) | |
| 1st/Reverse Brake | .032-.048 (.81-1.21) | |
| 2nd Brake | .033-.049 (.85-1.25) | |
| 2nd Coast & O/D Brake | .082-.098 (2.09-2.49) | |
| Side Gear Backlash | .002-.008 (.05-.20) | |
| Torque Converter Runout (Maximum) | ||
| Drive Plate | .008 (.20) | |
| Sleeve | .012 (.30) | |
| Torque Converter Installed Depth | ||
| U340E | .366 (9.30) | |
| U341E | .524 (13.30) | |
CLUTCH DISC & PLATE QUANTITY
| Component | Discs | Plates | |
|---|---|---|---|
| Direct Clutch | 3 | 3 | |
| Forward Clutch | 4 | 4 | |
| Reverse Clutch | |||
| U340E | 2 | 2 | |
| U341E | 3 | 3 | |
| 1st/Reverse Brake | 4 | 4 | |
| 2nd Brake | |||
| U340E | 3 | 4 | |
| U341E | 4 | 3 | |
| 2nd Coast & O/D Brake | 2 | 3 | |