Stop Light System: Inspection

INSPECT STOP LIGHT SWITCH CONTINUITY

STOP LIGHT SWITCH CONTINUITY

Switch position	Tester connection	Specified condition
Switch pin pushed in (Pedal released)	-	No continuity
Switch pin free (Pedal depressed)	1-2	Continuity

If continuity is not as specified, replace the switch.

Fig 1: Inspecting Stop Light Switch Continuity

G02575984

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

INSPECT HI-MOUNTED STOP LIGHT CONTINUITY (SEDAN)
Using the ohmmeter, check that continuity exists between terminals.

If continuity is not as specified, replace the light assembly or bulb.

Fig 2: Inspecting Hi-Mounted Stop Light Continuity (Sedan)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT HI-MOUNTED STOP LIGHT CONTINUITY (HATCHBACK)
Using the ohmmeter, check that continuity exists between terminals.

If continuity is not as specified, replace the light assembly or bulb.

Fig 3: Inspecting Hi-Mounted Stop Light Continuity (Hatchback)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002