Freeze Frame Data Of Abs

HINT:

• Whenever a DTC is detected or the ABS operates, the skid control ECU stores the current vehicle (sensor) state as freeze frame data.
• The skid control ECU stores the number of times (maximum: 31) the ignition switch has been turned from off to the ON position since the last time the ABS was activated. However, if the vehicle was stopped or at a low speed (4.3 mph (7 km/h) or less), or if a DTC is detected, the skid control ECU will not count the number since then.
• Freeze frame data at the time the ABS operates:

  The skid control ECU stores and updates data whenever the ABS system operates.

  When the ECU stores data at the time a DTC is detected, the data stored when the ABS operated is erased.

• Freeze frame data at the time a DTC is detected:

  When the skid control ECU stores data at the time a DTC is detected, no updates will be performed until the data is cleared.

1. Connect the Hand-held tester to the DLC3.
2. Turn the ignition switch to the ON position.
3. From the display on the tester, select the "FREEZE FRAME DATA".
   FREEZE FRAME DATA
   
   

   Hand-held tester display	Measurement Item	Reference Value*
   VEHICLE SPD	Vehicle speed	min.: 0, max.: 326.4 km/h
   STOP LIGHT SW	Stop light switch signal	Stop light switch ON: ON, OFF: OFF
   #IG ON	Numbers of operations of ignition switch ON after memorizing freeze frame data	0 to 31
   SYSTEM	System status	ABS activated: ABS, NO SYS, FAIL SAFE
   TROUBLE CODE	Freeze DTC	min.: 0, max.: 255
   SPD GRADE	Vehicle speed grade	min.:-1.869, max.: 1.869
   #CODES	Number of trouble code	min.: 0, max.: 255