Inspection Procedure

NOTE: When replacing the ABS & TRACTION actuator assy, perform zero point calibration (see CALIBRATION ).

RECONFIRM DTC
HINT: These codes are detected when a problem is determined in the ABS & TRACTION actuator assy.

The solenoid circuit is in the ABS & TRACTION actuator assy.

Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if the DTC code is output before replacing the ABS & TRACTION actuator assy.
1. Clear the DTCs (see DTC CHECK/CLEAR ).
2. Turn the ignition switch to the ON position.
Are the same DTCs recorded?
1. NO: END
  HINT:
  
  The DTCs may be memorized due to a malfunction in the connector terminal.
2. YES: GO TO NEXT STEP.
  REPLACE ABS & TRACTION ACTUATOR ASSY (SEE REPLACEMENT )