Inspection Procedure
NOTE:
When replacing the brake actuator assy, perform zero point calibration (see CALIBRATION
).
- RECONFIRM DTC
HINT:
These codes are detected when a problem is determined in the brake actuator assy.
The solenoid circuit is in the brake actuator assy.
Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if the DTC codes are output before replacing the brake actuator assy.
- Clear the DTCs (see DTC CHECK/CLEAR ).
- Turn the ignition switch to the ON position.
- Are the same DTCs recorded? (see DTC CHECK/CLEAR )
- NO: END
HINT:
These DTCs may be memorized due to a malfunction in the connector terminal.
YES: REPLACE BRAKE ACTUATOR ASSY (SEE REPLACEMENT )