How To Proceed With Troubleshooting

HINT:

The hand-held tester can be used at steps 3, 6, 9, 12.

1. Vehicle Brought to Workshop 

   Go: to Next Step

2. Customer Problem Analysis (See  CUSTOMER PROBLEM ANALYSIS CHECK   ) 

   Go: to Next Step

3. Check and Clear DTCs and Freeze Frame Data (See  PRE-CHECK   ) 

   Go: to Next Step

4. Problem Symptom Confirmation 
   1. Symptom does not occur: Go to step 5 
   2. Symptom occurs: Go to step   6 
5. Symptom Simulation (See  ELECTRONIC CIRCUIT INSPECTION PROCEDURE  ) 

   Go: to Next Step

6. DTC Check (See  PRE-CHECK   ) 
   1. There is no output: Go to step 7 
   2. There is output: Go to step   8 
7. Problem Symptoms Table (See  PROBLEM SYMPTOMS TABLE   ) 
   1. Check for fluid leakage and go to step   10 
8. DTC Chart (See  DIAGNOSTIC TROUBLE CODE CHART   ) 

   Go: to Next Step

9. Circuit Inspection (See  DTC C0200/31 RIGHT FRONT SPEED SENSOR, DTC C0205/32 LEFT FRONT SPEED SENSOR, DTC C1330/35 FOREIGN MATTER IS ATTACHED ON TIP OF RIGHT FRONT WHEEL, DTC C1331/36 FOREIGN MATTER IS ATTACHED ON TIP ON LEFT FRONT SENSOR   to  DTC C1300/62 SKID CONTROL ECU MALFUNCTION   ) 

   HINT:

   When 2 or more DTCs are detected, perform circuit inspection one by one until the problem is identified.

   Go: to Next Step

10. Identification of Problem 

    Go: to Next Step

11. Repair 

    Go: to Next Step

12. Confirmation Test 

    End