Steering Sensor: Replacement

PRECAUTION
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (SEE PRECAUTION )
PLACE FRONT WHEELS FACING STRAIGHT AHEAD
REMOVE STEERING WHEEL COVER LOWER NO.2 (SEE REPLACEMENT )
REMOVE STEERING WHEEL COVER LOWER NO.3 (SEE REPLACEMENT )
REMOVE HORN BUTTON ASSY (SEE REPLACEMENT )
REMOVE STEERING WHEEL ASSY (SEE PRECAUTION )
SST 09950-50013 (09951-05010, 09952-05010, 09953-05020, 09954-05021)
REMOVE STEERING COLUMN COVER LWR (SEE PRECAUTION )
REMOVE STEERING COLUMN COVER (SEE PRECAUTION )
REMOVE SPIRAL CABLE SUB-ASSY (SEE REPLACEMENT )
REMOVE STEERING SENSOR
1. Disengage the 6 claws and remove the steering sensor from the spiral cable.
  
  Fig 1: Removing Steering Sensor From Spiral Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING SENSOR
1. Install the steering sensor to the spiral cable.
  NOTE:
  - Engage the claws securely.
  - Do not damage the claws.
  Fig 2: Installing Steering Sensor To Spiral Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT SPIRAL CABLE SUB-ASSY (SEE REPLACEMENT )
PLACE FRONT WHEELS FACING STRAIGHT AHEAD (SEE REPLACEMENT )
INSTALL SPIRAL CABLE SUB-ASSY (SEE REPLACEMENT )
CENTER SPIRAL CABLE (SEE REPLACEMENT )
INSTALL STEERING WHEEL ASSY (SEE PRECAUTION )
INSTALL HORN BUTTON ASSY (SEE REPLACEMENT )
INSPECT HORN BUTTON ASSY (SEE REPLACEMENT )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
INSPECT SRS WARNING LIGHT (SEE DIAGNOSIS SYSTEM )
PERFORM INITIALIZATION (SEE INITIALIZATION )
1. Some systems need initialization after reconnecting the negative battery cable.