LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2004 >> Tundra Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 472 (Can Communication System - Diagnostics) >> Can Communication System >> Diagnostic Trouble Code Chart

Diagnostic Trouble Code Chart

WARNING: This page is about a different car, the 2006 Toyota Tundra and 2005 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

DTC TABLE BY ECU 

HINT:

If CAN communication system DTCs are output, trouble cannot be determined only by the DTCs. Perform troubleshooting according to "HOW TO PROCEED WITH TROUBLESHOOTING" (see HOW TO PROCEED WITH TROUBLESHOOTING  ).

  1. Skid Control ECU

    HINT:

    DTC communication uses the SIL line.

    DTC AND DETECTION ITEM

    DTC No. Detection Item
    U0073/94 Control Module Communication Bus Off
    U0100/65 Lost Communication With ECM/PCM "A"
    U0123/62 Lost Communication With Yaw Rate and Deceleration Sensor Module
    U0124/95 Lost Communication With Lateral Acceleration Sensor Module
    U0126/63 Lost Communication With Steering Angle Sensor Module
  2. ECM

HINT:

The ECM is connected to the CAN communication system but CAN communication system DTCs are not output.